Check the position of the flange fork of the universal joint shaft
The universal joint shaft is elastic and flexible, so the strength of its flexible vibration and the critical bending speed must be carefully calculated, and its maximum allowable speed must be completely lower than the critical bending speed provided at the first order. When using a telescopic universal joint shaft, the flange of the connected part must be firmly fixed on the universal joint shaft. Use bolts and screws of specified material (strength). When installing the universal joint shaft, do not move the flange fork at Wholesale CV Joint manufacturers will to avoid injury.
Check the position of the flange fork of the universal joint shaft, pay attention to its arrow mark, and it must be carefully calibrated, and it is forbidden to replace and change the spline at will. When spraying the universal joint shaft, be sure to confirm the sliding range of the seal ring. Remove the transportation protection materials (such as baffles, etc. Once the accident occurs, the consequences are very serious. It is forbidden to use the installation lever to rotate the universal joint, so as not to damage the oil nozzle and the pressure reducing valve.
If you have any doubts, please contact the supplier. Use the bolts and screws required by the supplier. If the storage period of the universal joint shaft exceeds 6 months, it should be relubricated before use.. To ensure the safe connection of the universal joint shaft, the flange of the universal joint and the surface of the flange of the connected part must be kept free of dust, oil and paint. The bolts should be tightened symmetrically and evenly with a torque wrench. When a fixed-length universal joint shaft is used, one of the connecting parts of the universal joint shaft is elastically connected to the positioning pin of the flange, and a suitable bearing adjusting device is used to adjust the length compensation caused by temperature changes.
The purpose of this is to prevent accidents such as slipping and falling of the universal joint shaft during rotation.The universal joint shaft must be equipped with complete and appropriate safety protection devices during the rotation process. Variety. In order to ensure the safe and stable rotation of the universal joint shaft, it is forbidden to exceed the value range of the corresponding universal joint shaft size (speed × inclination).) before installation. How should we do safety protection during the shaft rotation? What safety protection should be done during the rotation of the universal joint shaft?