The time for adding and changing grease should be determined
Temperature control at the use site is an extreme situation. At the same time, taking into account the factory pre-filling oil and daily grease The actual oil filling time is about 3-5s.6-0. If this happens, it needs to be repaired # as soon as possible. If the grease nipple is smashed into the hexagonal deformation or the grease nipple is rusted, etc.85s. During the replacement process, keep the area around the interface clean to prevent the mixing of mechanical impurities, dust and sand.
For the SWC350 cross shaft assembly mentioned in the article, the bearing cavity is filled with oil, and the contract is 6. Therefore, every place needs to use a more suitable protection method. Insufficient intake pressure of grease gun.8 MPa. Under what problems, the cardan shaft can't enter the oil: Check the above situation first. When the cardan shaft is running, it is easier to cause problems for the person and the device. Why do we say that in some cases, workers will make a misjudgment that they can't get in the oil?
The oil delivery rate of a common pneumatic high-pressure oiler is about 0. Therefore, the time for adding and changing grease should be determined according to the specific usage. It uses the action of a pump to generate high pressure for the oil, and uses high pressure for oil injection. Whether the oil filling hole is blocked. When there is a load, the thickener releases the oil, thereby providing lubrication.
We will use suitable grease during design and production to meet your needs. It has good water resistance, mechanical safety, and waterproofing. WhenDrive Shaft Suppliers connecting, all connecting parts must be cleaned, and the nut must be tightened with a wrench to avoid oil leakage. It is not suitable to add grease. Pay attention to starting the air compressor before use, and prepare the compressed air of 0. There are many problems encountered in the installation and maintenance of mechanical products